Some also pointed out the scope AFC work between departments to facilitate the deployment of shop drawings This is the basis for comparison, check if during fabrication and installation has incurred any problems. Tutorials Read piping isometric drawings ProjectĪFC's drawings we received an official copy of the design to construction commencement. These are drawings used to construction commencement include 2 types are drawing AFC (aproved for Construction) and shop drawings also called IFC (Issue for construction). ), the location of contact between the two or two types of materials on the same pipeline Class. P & ID provides the basic information, but rather full of all kinds of devices, control panel, explaining the symbols (applies to both isometric drawings), the scope of work (Onshore or Offshore, or Piping Instrument. P & ID (Piping and Instrumentation Diagram: The drawing includes piping systems, equipment, instrument and control signals (Get detailed instructions in other documents). Therefore, this document can not be used for the process engineer or related issues in the design and procurement. The course content is limited to the monitoring, the piping engineer newly graduated should remain many shortcomings. There is a no size but stature most important (P & ID), there are drawings of size but not right ratio (isometric), with drawings only show ground floor (Piping GA ), have detailed drawings to each section (Pipe Support). The drawing is the main base to manufacture and install and test the simple to the more complex device clusters, so the information from drawings provided are varied and plentiful. In general engineering and the petroleum industry in particular is drawing the main tool for the development of design ideas to actual construction.
0 kommentar(er)
